Installation sled wrap

Ensemble en vinylWhen you get your shipment in the mail:

When you receive your sled wrap remove the pieces from the tube and lay then on a flat surface for 12 to 24 hours.

During this time make sure your snowmobile is in a warm location (around 21 degrees celsius).

ICONES_SITE_3_GOUTTEClean and prepare your snowmobile:

Remove any existing graphics or decals if they will be in the way of the new wrap using a heat gun.

Ensure that any glue residue, dirt or grime is removed by cleaning with 70/30 isopropyl alcohol. You can find this product in hardware stores, pharmacies etc.

ICONES_SITE_3_CISEAUPreparing the sled wrap:

When you are ready to install the sled wrap, we recommend cutting each specific piece out of the large print template while leaving the backing material on the decals.  This will allow you to lay these pieces out on the snowmobile panels to align them properly.  Use masking tape to secure each piece temporarily so that you can align correctly.

ICONES_SITE_3_CASSE_TETEInstallation procedure:

Once you have all of the pieces temporarily aligned, take a long piece of masking tape and stick it in the center of each piece and to the hood/side panel areas.  This tape will act as a hinge for proper alignment.  Once that is done, remove the backing material from one side (50%) of the decal and cut it away.  Then, work the individual piece onto the area going from center towards the outer edge.  This will help to eliminate air bubbles and insure proper adhesion.

Once the first half of the decal is set, remove other half of backing material and follow the above steps to finish.

ICONES_SITE_3_AMPOULEHelpful tip:

It is recommended to have an ample heat source such as a heat gun or blow dryer.  Heating up the material slightly will make it much easier to work.  Do not get it too hot, just warm.

Avoid washing or using any other products until completely dry. Products such as RapidTac can be purchased to assist with the installation.

ICONES_SITE_3_SOLEILFinal heat step:

It is critical when installing to ensure any and all air or water from wet applications is completely dissolved and dry before exposing to winter temperatures.

Regardless of your install technique post heating surfaces and applying extra pressure is also highly recommended for avoiding premature release.

Lack of post heating all surfaces would constitute as improper installation.

In order to optimize the results, keep your snowmobile in a heated area for 12 hours after installation.

Download the plans:

Ski-Doo XM Plan Part 1

Ski-Doo XM Plan Part 2

Ski-Doo Rev XU Plan

Ski-Doo XP Plan

Pro RMK Rush Plan

Ski-Doo GEN4 Plan

Polaris Plan

Sign up for our newsletter.

 

Popular products

Share